Battlefield V’s creators: female characters are ‘here to stay’ | 19mm Momentary Push Button

I flashed Tasmota firmware onto the Sonoff, and configured GPIO2 as a counter, and I now have the whole setup reporting to Node Red, which switches the pumps on and off on schedule, or as desired. I’m quite chuffed with the result, although now I need to learn a lot more about how Node Red works!

By using our website and services, you expressly agree to the placement of our performance, functionality and advertising cookies. Learn more Accept

The theory side of PCB creepage clearnesses is useless because it assumes that there is one constant voltage that the circuit will run at when in reality it’s an over voltage event that usually causes failure, but here are the basics anyway.

Being small and shiny, it was an almost dead cert that a new engineer would pick it up, When tipped over, the relay would be energized by the tilt switch, the relay then switched off its own power, which resulted the contacts closing again, resulting in oscillation, and large back emf spikes which were presented across the two metal plates. As a result the person who picked up the box got a fairly significant belt, and let out some major expletives.

Thanks to the MOVs’ high energy dissipation, they can be used to suppress lightning and other high-energy transients found in ac power-line applications. They’re equipped to withstand large amounts of energy and divert this potentially destructive energy away from sensitive electronics located downstream. MOVs, which are also used in dc circuits, come in a variety of form factors (Fig. 1).

In this case, multiply the number of times you charged the car by 8.9 kWh for a low estimate of electric power consumed. For a better estimate, you need to know what the battery charging losses are. It takes more than 8.9 kWh to charge an 8.9 kWh battery – some of the power gets lost to heat. I can’t find authoritative data, but posters on Tesla forums claiming to have measured this report losses between 10 and 20%. If you assume it’s 15%, then it’ll take 8.9 / (1 – .15) = 10.5 kWh to charge the Niro’s battery.

Where I do agree that it is under rated, as far as I know, Mathias is an electrical engineer. So he should be able to work with mains, and he should also know better.

The best tip for buying a portable home generator: Don’t wait until the lights go out. Whether you live in a place at the mercy of snowstorms, hurricanes, heat waves or an outdated electric grid, a power outage can range from an annoyance to life-threatening.

I love the concept and the build. But does potting with epoxy resin have enough strength to hold magnets in place? I did not see any mechanical fastners holding magnets in place . If epoxy cracks I see magnets pulling out of metal bracket and failure .Over to someone with engineering experience please.

If you hesitate at the thought of doing this math for every system you work on, the NEC Article 110.3(B) states: Listed or labeled equipment shall be installed and used in accordance with any instructions included in the listing or labeling.

One more thing. If you are not a electrician you should not be playing with Live power. Like you said you almost killed your family, And Possibly more people.

Still, the orderly May backdrop registers as bullish, versus the prior three months, punctuated by the S&P 500’s flag pattern pinned to the steep early-month rally.