Does Tesla Make The Best Value EVSE For Non-Tesla Owners? | Lrd12 Overload Relay

These were obviously mistakes. I would never intentionally come into contact with HT from the anode cap.

Agreed, this is a house fire waiting to happen and your insurance co. won’t give you a cent if an investigation points to this homecooked thing as the firestarter. There are numerous commercial alternatives which are small enough to fit in a junction box _and_ are UL/FCC/CE approved. Granted, they aren’t as cheap as the ESP module and the triac described here, but in the end, most cheap alternatives to switching powerful currents turn out to be very expensive after all.

Regular gasoline costs about $3 per gallon where I live, so it’ll cost (26 / 46 * 3) = $1.70 to propel the Niro the next 26 miles after the battery is depleted.

Yes you can use those high voltage safely, BUT your typical DIY people don’t even bother to read or understand datasheets. These people need the proper training, but aren’t likely to be bother to go beyond the typical monkey see monkey do watching youtube and think they know it all. I have seen enough of bad layouts of the average projects that doesn’t even understand that the creepage space between the primary and secondary side of an optoisolator aren’t meant to be for routing!

So far we have discussed your bench and associated equipment. We are not however quite done though, because there is one final component in keeping your bench safe: you. If you have a piece of equipment in front of you and you are about to open it up, the most significant part of your safety routine doesn’t lie with your equipment, but in how you approach it.

Is it possible, that the discreet triplers (vs. diode split transformer) were in the time of BW-TV? They had lower power. Or the guy tested the AC before the tripler, I think that would make a great difference. Although I also would not do this intentionally. There would also be a nice arc to a grounded screw driver, if you want to test the HT – without any current path through myself, what I really prefer. The electrician, whom you mention, did he really die while testing for voltage with his hand, or was his accident unrelated to this?

Still, most capitalists, when you order something, don’t ask “what do you want it for?”, so they can substitute something else without telling you. Generally in contracting with capitalists, mysterious “problems” don’t regularly as clockwork pop up, increasing the cost above what was agreed.

So a 20 amp breaker is designed to take the load shift on startup. A 15 amp breaker will carry the nominal load, but that surge on startup will kick it every time. In the days before switching supplies the input voltage would vary from 108 to 115VAC where I did work. This occasionally caused breaker trips on the unprepared circuit. I learned to spec high enough to minimize that issue and keep a safety factor in play.

I think every power MOSFET in my box, most of them from reputable sources, have packages rated below the die.

I believe two-man saws bite both directions. And if they don’t, then pretend that they do for the analogy.

The saw cuts in both directions, one person pulls, and the other slightly lifts and the saw cuts. then the other person pulls and the opposite person slightly lifts and follows the saw. Each person has a pull stroke and a less strenuous return stroke.

At the end of the day all power supplies deserve respect, not least because they’re more likely to kill you by burning your house down than through electrocution.