Google’s Night Sight for Pixel phones will amaze you | Lrd12 Overload Relay

https://www.aliexpress.com/wholesale?SearchText=magnetic+lifter 200kg at the flip of a handle. No electricity involved. (The 2000kg version has a bigger handle .

The TLDR; is – “In high voltage systems clearance according to EN60065:1994, 3 mm is required for Class I and for Class II, 6 mm is required in mains operated systems (240VAC)”

So the 12 / 24 V designs aren’t an illusion of safety, they are safer if you accidentally short yourself to them

You’ll notice that there’s a single general lighting circuit that’s warmer than the other breakers in this panel; again, it’s only a small increase in temperature, so I’m not concerned. If it were much warmer, I might question why.

We recently watched [MakeItExtreme] turn a couple of microwave oven transformers into a somewhat ill-advised wall-climbing rig. It looks like that may have been the inspiration for this build, and the finished product appears to be a tad more useful this time. The frames of three MOTs are cut open to remove the secondary coils and leave the cores exposed as poles for the future magnets. A shallow dish is fabricated out of steel and the magnets are welded in place.

Experts suggest buying an EVSE that can produce at least 30 amps of power. Generally speaking this type of unit would be able to add around 30 miles of operating range to a given battery pack per hour. Some EVs can get along with fewer amps, but buying more capability than you may need today makes the installation “future proof” should you eventually trade in the vehicle for a model that can handle the added capacity. However, if you’re planning on using a 30-amp unit you may need to upgrade the line’s circuit breaker to one that’s rated for at least 40 amps.

A mains isolation transformer. wdwd [GFDL], via Wikimedia CommonsAn isolation transformer isolates the mains supply from the earthing system. This does not change any of the risks inherent to the mains voltage or other high voltages in your device, but it does provide you with some level of protection should you accidentally provide a path to earth from a live component.

In the second week, I’m not even sure why I did it, I was working on a pinball machine and measured 240V between the chrome plates on the front of the 2 pinball machines to either side of the one I was working on. The electrician had “forgotten” to hook any of the earths for the whole building.

The first was working with a bench buddy on a military SSB Shortwave amp. My bench buddy assured me he had powered the system down and unplugged everything necessary, and I trusted him. I reached in with a pair of needle nose pliers to remove the plate voltage supply on the amp tube, and got hit by 26kv DC. Shouted and was teleported backwards about 3 feet, but no damage done (except a small melted bit on the end of the pliers).

True enough; This hack goes back decades floor finishers who have large floor sanders use this hack to run their large sanders.

i built the rig that day. I put an ammeter with max hold on a circuit, plugged the circuit into a known 20 amp connection, and put a load on the circuit that simulated the instrument. Turn it on, 22 amps max hold, 13 amps nominal.

Then when you step up a notch to the KV stage the safety rules change because air can now be a conductor.