Here’s a sure red flag the home contractor you’re considering is untrustworthy | 25 Amp Circuit Breaker

All silly, make graphene in a blender combine it with acrylic paint, then paint it on. Making heated beds is anything but an art form. Or just use graphite.

Theres a homebrew 80vdc @150amp supply in my cnc converted bridgeport, that runs the entire dc rail for the steppers and other stuff, its always scared me slightly because I know that the big transformer its based on has a mag field and when it collapses and it has some massive smoothing capacitors to boot, so I have masses of isolation distance everywhere the dc side runs and I disable the transformer with a dedicated switch while working in the cabinet of it. I had a stepper driver supplied directly off the rail go bad and it just had a large hole where it used to be. I just imagine that was a bit of me if I get tempted to get sloppy with it. I’ve never put much thought into getting electrocuted by a welder, I’ve tickled my finger with my 3 phase tig set more than a few times getting too close and giving a nice easy starting path to the startup pulse. Maybe I should, I’ve got a massive 3 phase 380v transformer tig that can do 375amp dc, that tends to throw all the breakers out while its saturating its massive transformer with the inrush current… I try to treat mains voltage with the respsect it deserves. Its a killer, but if you take sensible precautions and steps you can avoid it being you it happens to.

*Using approved LO/TO procedures which include verifying the energy sources are removed/disappated and safe

From the Auris to this, haven’t Toyota learnt anything. It’s just a slightly bigger and slightlly less DULL than the car it replaces.

Toasters kindof have to use mains voltage, there’s a kilowatt or so of power in there. They do their best to keep the mains voltage away from hands, you’d have to deliberately put your fingers in to get shocked. Always remember to switch off at the wall before you stick the knife in to dig out your crumpets!

No I don’t want one, because I have a computer museum and I don’t feel the need to instant-wipe all my floppy disks at the flip of a switch.

On the positive side, the mechanism does allow the LCD to be folded facing inwards, providing some degree of protection against minor knocks and smudges when traveling and when you’re content to use the EVF instead. The Xtra Fine LCD panel has a 921,600-dot resolution. The display also uses Sony’s TruBlack technology, which couples a reinforced glass cover plate with anti-reflective film, and a resin filling that removes the air gap beneath the cover plate, which the company says improves contrast and reduces glare under harsh sunlight.

In Finland pretty much every household is wired with 3x 230V phase, with main fuses between 25-63A. Nominal voltage from phase to ground is 230V and phase to phase 400V. Load is split between phases, so that phase voltages would stay same, usually this is done by grouping different rooms to different phases, commonly 10A 230V per room sockets and lights.

Best answer: Probably. The Amazon Smart Plug was designed to work with most any product you have in your home but there are some exceptions and devices that shouldn’t be connected.

仲鑫达倡导“勤奋、求实、开拓、发展”的企业精神，在企业内部构建积极向上、团结协作、创新进取的企业文化和人才环境。

The first was when I was a wee, messing w/ a big 24v motor w/ weight (read: kickback voltage as it spools down && lots of amperage) and I turned it on w/ my hands on both leads…

1. 25A for 22A? Too close for my comfort. 2. A thin sheet of aluminum is not much of a heat sink. 3. Sitting on top of the hot water heater means ambient temp is going to be a bit higher. 4. Summer in a garage is likely to get hot.