Ohio will let businesses pay their taxes with Bitcoin | Lrd12 Overload Relay

The first time I hooked up to HT it was a 32+ inch screen (about 27KV) and it launched me into the air and I landed 4 meters behind where I was sitting. The second time was a 27 inch (about 24KV) and there was a wall about two meters behind me and I was slammed into that so hard that I was bruised in many places.

The customer wasn’t pleased. I had obviously done something wrong. I showed them the paperwork with the specifications showing that the input to the dimmers was to be 20 amps. They insisted that their electrician knew better than I did.

I can only think of a single instance in the last six months where the HPWC higher charge rate would have made a difference for us, and even then it would have simply made leaving for a long trip slightly more comfortable.

This makes a lot of sense. There are many rather cheap dimmers that can drive a 500W ‘flood’ lamp, so it’s probably better to modify one of theses, and keep it outside the wall socket…

WASHOUGAL — To hear Shirley Scott tell it, this town’s recent drive toward proliferating public artworks was born out of…

Considering the existence of deep subzero freezers, it would still perform better than a resistive element. Or have it draw the heat from the indoors and run some crypto miners to make up for it.

Over and over again, I have heard HVACR technicians and electricians quote rules of thumb regarding wiring sizing, and I have witnessed and participated in many heated debates on the topic.

Not always, you have to think on a global scope here before saying generalizations! In the UK a lot of houses are on what they call PME or protected multiple earths, where the earth bond goes back to the substation as a extra conductor. If you are in one of these properties and are not aware of it, and have your own ground system or leakage you can end up being lower impedance than the substation ground and grounding out faults in your neighbors properties which are also on the same bond. Where I am in europe, all the houses are individually bonded to their own low impedance earth, and the inspector comes out with a megga tester and tests its impedance before they will sign you off to connect to the public supply. It has to be below 50ohms total from any gnd pin on any socket in the property I remember from my inspection. I laid a load of mesh subfloor before pouring the floor so I had no problems with meeting spec. A nice low impedance earth will make your rcd and protection devices even more sensitive also.

The outlet on your wall is likely on a 15 amp circuit, so in many cases, the Smart Plug can handle as much power as the breaker or fuse can. To see what the power requirements of many electrical devices are and what type of load they create, you should visit Electrical Safety First. It’s a site based out of the UK, but the power ratings for products are the same no matter which country you use them in and the charts here are an invaluable tool.

This is true in a certain temperature range, I think between 70 and 90% of their nominal power. And in spite of that there are so many lamps with halogen bulbs, which are fitted with dimmer circuits. And you know why? Because the bulbs are very cheap, so nobody cares And they are often used as heating elements: in a professional reflow oven (3000,- euro class) and in laser printers. But in the end I think for the heated print bed you do NOT want a radiative heat source, it complicates the things

Europe is a real patchwork of degrees of sketchy. German wiring standards are very high indeed, at least in the semi-industrial places (laboratories, hospitals) I worked. The real Schuko plug/socket design is quite nice and safe, and hard to find *not* implemented correctly in Germany. Other countries, not so much. And don’t get me started on English and South African wiring and plugs.

The rear seats are nearly as roomy as the fronts , which is an incredible achievement for such a compact car. Never did the kids knee my seatback.