The end of Instagram as we know it is here | Lrd12 Overload Relay

I really do like the C-Max, as it’s a compelling value, and it actually drives fairly well in my opinion.

The net result is that, while the Sony Alpha A33 is a fair bit thicker front-to-back than single-lens direct-view (SLD) cameras, which can do away with the bulky mirror box entirely, it’s still an exceptionally small camera by SLR standards. If the handgrip depth is ignored, the Sony A33 is actually just a little smaller than the smallest digital SLR to date, the Olympus E-420. Unlike the smallest SLD cameras, the A33 still includes a built-in electronic viewfinder — and for those SLDs that can accept an optional electronic viewfinder, much of their size advantage over Sony’s SLT-series models is erased once it’s installed. Sony’s A33 thus occupies a comfortable middle ground, sacrificing little of the versatility of a traditional SLR, yet bringing a worthwhile advantage in portability.

If you have an older system, you might like to see more of a pool system rebuild. If you are interested in controlling the pool chemistry, we’ve seen that before, too.

What’s the big deal? The heated rock for my herpetarium plugs directly into the wall. Nice cozy and warm. No shocks for me, no limp lizard either.

Isn’t welding the core kind of a bad idea as it will short the laminated plates and make it heat a lot?

Great reasons to add L2 to your own garage, carport, parking spot: preconditioning vehicle will not reduce your SOC, lower fire risk than overloading an existing 120V circuit, more efficient charging, added resale value to your house, NEMA 14-50 outlet can be used for other things (welder, RV, heater, etc.), two EVs in the same garage, maximize off-peak charging, cool factor, etc.

These were obviously mistakes. I would never intentionally come into contact with HT from the anode cap.

▲ 仲鑫达自动化设备有限公司专业从事制氢及供氢系统的研发、生产、销售和售后服务，对制氢供氢工程的设计、安装、调试运行和后期保养维修，都具有丰富的实践经验。

The remote has a few buttons and LED for status. The LED reacts differently depending on the pool’s current mode, so connecting there not only gives you control but also allows you to provide some limited status. It isn’t going to let you monitor pump currents or anything exotic, but it is a simple place to gain access. Using the Arduino pulse input function makes it easy to sense if the LED is on, off, or blinking. Another sensor reads the water temperature. The controller makes it available, but it isn’t simple to read, so the project just reads the raw sensor voltage from the existing thermistor and computes the temperature.

If you can tell me the relation between MOC max or peak amps values and the switched power done by the MAINS BT137 Triac I will be more than happy to hear….

Looking at the datasheet for the Fotek SSR-25DA:https://cdn.sparkfun.com/datasheets/Components/General/SSR40DA.pdf

True enough; This hack goes back decades floor finishers who have large floor sanders use this hack to run their large sanders.